Bumper Crop High Potassium Fertiliser | N.P.K: 15-7-32+3Mg
Bumper Crop High Potassium Fertiliser is a superb high potassium feed to encourage abundant flower production and plentiful fruit growth. Potassium is an essential plant nutrient and is required in large amounts for proper growth and reproduction of plants. Potassium is considered second only to nitrogen, when it comes to nutrients needed by plants, and is commonly considered as the “quality nutrient.” It affects the plant shape, size, colour, taste and other measurements attributed to healthy produce.
To promote flowering and subsequent fruit production. Improves flavour and increases sturdiness of plants and shelf-life of fruit.
Use from the onset of flowering until harvest time.
Rate of Use –
The standard rate is 1g / litre of water. However this can vary anywhere between 0.5g / litre – 2g / litre. Use the lower rates for sensitive plants, such as pot plants under glass. The higher rates should be used on rapidly growing plants in outdoor soils.
DO NOT exceed 2g / litre.
Liquid Feed Application:
Used in the same way as other water-soluble fertilisers. Feed is usually applied via a normal watering can. Simply add the appropriate amount of Feed to the can, add water and apply liberally to the plant root area. A very approximate guide is 5litres / square metre.
Feed is best applied as a liquid feed whilst the plant is actively growing. Ideally alongside watering.
Plants are designed to take up nutrients through their roots, but most nutrients can be absorbed through the leaves. Foliar feeding can give crops a valuable boost. Particularly if the root system is not functioning well due to drought, disease or pest attack and other stress factors.
Feed can be applied to plants foliage via a hand or knapsack sprayer or similar equipment.
Whilst using a sprayer the following points should be observed:
Use a sprayer nozzle that produces a fine mist.
Only apply sufficient spray solution to to coat the leaves and stems with a film of moisture with little or no “run-off”.
Carry out spraying on a calm day, but not during strong sunshine or high temperatures. The best time is late afternoon or evening.
Postpone spraying if rain is imminent. If rain falls within 4 hours of spraying, re-spray the crops 3 or 4 days later.
For application via hose-end diluters, please refer to the device manufacturer’s directions for use.
If you are in an area with acute hard water, Soluble NPK fertilisers can dry on the leaves and leave unsightly residues.
Rate of Use:
Prepare a 0.05 – 0.1% (0.5 – 1.0 g / litre) solution and apply to coat the leaves and stems with a thin film of moisture, with little or no “run-off”. DO NOT exceed a 1g / litre concentration.
2 : 1 : 4 (15:7:32+3) NPK
|Total nitrogen (N)||15.0|
|Nitrate nitrogen (N)||8.1|
|Ammoniacal nitrogen (N)||–|
|Ureic nitrogen (N)||7.0|
|Phosphorus pentoxide (P2O5)||6.9(P:3.0)|
|Potassium oxide (K2O)||32.0(K:26.5)|
|Magnesium oxide (MgO)||3.0(Mg:1.9)|
|Boron (as polyborate)||0.021%|
|Copper (as EDTA)||0.010%|
|Iron (as EDTA)||0.175%|
|Manganese (as EDTA)||0.060%|
|Molybdenum (as molybdate)||0.005|
Check out our range Bumper Crop Fertilisers here.